Download to read offline
![After session created, you can use “ch -sn [session name]” to switch into the session...](https://image.slidesharecdn.com/windowsserialconsoleusageguide-170330151107/75/GCE-Windows-Serial-Console-Usage-Guide-4-2048.jpg)
Uploaded bySimon Su
GCE Windows Serial Console Usage Guide
This document provides instructions for enabling and using the serial console on a Windows machine. It outlines connecting to the VM from port 3, using "?" to check available commands, running "cmd" to start a new command session, and "ch -sn [session name]" to switch sessions. Finally, it notes you can reset the password using "Create or reset Windows password" and login to access the Windows command prompt for troubleshooting.
GCE Windows Serial Console Usage Guide
- 1. Windows serial consoleusage guide Simon Su / 20170330 Enable serial console for the machine: Connect VM from “Port 3”
- 2. After enter intoSAC console, you can use “?” for check available commands...
- 3. Use “cmd” tostart a new command session...
- 4. After session created,you can use “ch -sn [session name]” to switch into the session...
- 5. After connect in,you can press enter to goto login page: You can use “Create or reset Windows password” for renew password...
- 6. And enter theuser and password into login page and you will got the windows command line prompt if success... After everything success, you can do any troubleshooting in the connected console...