-
|
On the BT firmware, one has access to a lot of settings, like whether to show the smiley or not, T&H offsets, etc. Is this possible on the Zigbee firmware? I know that you can click "Manage zigbee device" on ZHA devices in Home Assistant, but the options in there are not at all clear to me. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 4 replies
-
|
It supports only basic functionality for now. But you can compile your own firmware without smiley or like that |
Beta Was this translation helpful? Give feedback.
-
|
Alright, thanks for the reply. |
Beta Was this translation helpful? Give feedback.
-
|
How can we flash the device again? It stopped appearing as a Bluetooth device on Telink flasher. |
Beta Was this translation helpful? Give feedback.
-
|
You may update the device via Zigbee OTA with zigbee2mqtt or ZHA. But flashing back to BLE firmware is supported only with soldering and UART. |
Beta Was this translation helpful? Give feedback.
-
|
First of all, great job! Is it possible to change the reporting interval in the ZIGBEE software, currently it is about 5 seconds and it quickly drains the battery |
Beta Was this translation helpful? Give feedback.
-
|
Reporting interval can be configured using standard zigbee reporting configuration. (It exists for zigbee2mqtt and I'm not sure about other coordinator software). It depends on value change and minimum and maximum time periods. The default configuration is 10-300 and 0.1ºC change. If the temperature is stable it should not send more often than 10 seconds, and will send at least one report in 5 minutes. But this behavior may be reconfigured on pairing by you coordinator. |
Beta Was this translation helpful? Give feedback.
-
|
Additional functionality to control smiley and calibrations have been added in version 1.1.0 |
Beta Was this translation helpful? Give feedback.
It supports only basic functionality for now. But you can compile your own firmware without smiley or like that