This is a DIY Flipper Zero-style multi-tool running on Raspberry Pi Zero 2.

Run the app on your Pi in BASH: cd flipperpi/web python3 app.py Then visit http://:5000 from any device on the same network.

FLASH RASPBERRY PI OS LITE:

Download Raspberry Pi Imager: https://www.raspberrypi.com/software/

OS: Raspberry Pi OS Lite (64-bit) Storage: Your microSD card

Click the gear icon in Imager: Enable SSH Set Wi-Fi SSID & Password Set hostname: flipperpi

Flash the card and insert into your Pi.

FIRST BOOT:

Power on the Pi Zero 2 W Defauly Passs: raspberry

Connect via SSH from your PC EX. PowerShell: ssh [email protected]

Update system in BASH: sudo apt update && sudo apt upgrade -y

INSTALL REQUIRED PACKAGES:

Install Python & Flask in BASH: sudo apt install python3 python3-pip git -y pip3 install flask spidev mfrc522

If you are using an RF CC1101 module via SPI, in BASH: sudo raspi-config Then Enable SPI, I2C (NFC reader requirement). Reboot once changed.

DEPLOY THE FLIPPERPI PROJECT:

In your host PC: EX. PowerShell: scp -r flipperpi_project_full [email protected]:/home/pi/

In the PI BASH: cd ~/flipperpi_project/flipperpi/web python3 app.py

TEST THE WEB UI:

On your host PC's browser: http://flipperpi.local:5000

Enter the PIN you set in app.py (default: 1234)

Try pressing: HID attack → Executes hid_keyboard.py RF send → Executes cc1101_send.py NFC read → Runs nfc_reader.py USB storage toggle → Runs usb_storage_toggle.py

SET FLASK TO RUN AT BOOT:

In PI BASH: sudo nano /etc/rc.local

Before the exit 0 line, add: python3 /home/pi/flipperpi_project/flipperpi/web/app.py &

Save and reboot: sudo reboot